Screwdrivers are the most important and most-used gunsmithing tools. Wheeler’s 89-pieceGunsmithing Screwdriver Sets belong on every gunsmithing bench. The well-thought-out bit selection will put an end to burred, buggered and busted up screw slots on any gun. Unlike other screwdriver suppliers, Wheeler’s engineers measured the screws on over one hundred modern and antique firearms to make sure that we offered bits for every situation. Whether you are working on a Browning® Superposed, a Remington® 700, a Smith & Wesson® revolver or a Colt® single action, you will find that there is a bit to fit every screw on your gun. The 89 piece set includes 15 ingenious “specialty bits”. These bits are great for installing scope bases, getting you out of a pinch by providing a small pin punch when you really need it and keeping once-in-a-while lifesaver tools at your fingertips.
Features:
• 54 hollow ground flat bits
• Doubles in the thinnest sizes
• Complete selection of Phillips, Allen, and Torx bits
• 15 specialty bits
• Hex to square driver adapter.
Kit Includes:
• Hinged storage box
• 2 handles
• 3" shaft extension
• Hex to square drive adapter (allows using the bits with a 1/4 drive socket wrench - wrench is not included)
• 54 flat bits
• 8 Allen bits sizes ranging from 1/16" to 3/16"
• 4 Phillips bits, #0, #1, #2, #3
• 3 Torx bits, T10, T15, T20
• Includes two each of the very thinnest bits in this set, this is intentional as the thinnest are most likely to break
• Weaver/Ruger scope ring clamp bit
• Redfield windage screw bit
• Leupold windage screw bit
• Mauser stock cross-bolt bit
• Millett rear sight adjustment bit
• 1911 grip screw bushing driver
• Ruger/Colt single action base pin latch nut bit
• M1/M14/M1A rear sight bit
• .062" pin punch
• .093" pin punch
• .118" pin punch
• Remington 870/1100/1187 trigger plate pin punch
• 2" #2 Phillips
• Glock replacement front sight screw bit
• S&W rebound spring compressor tool.
