This is and Italian made micro cell recoil pad 23mm thick, 150mm long, 50mm wide with a hole spacing of 92mm.
microCell is the new generation recoil pad by Cervellati srl, produced in an expanded technopolymer. Compared to the traditional pads in rubber or in gel,
microCell offers the following advantages:
microCell is 50-60% lighter;
significantly higher recoil absorption;
minimal deformation during the shot;
no “bottom out” effect over time
These recoil pads are extremely well made, and well finished, and would grace the stock of any gun no matter it’s manufacture, and look fantastic.
Grinding Instructions
1. For perfect adherence, flatten the stock’s back and wrap the stock to protect it during the process.
2. Lubricate the screws, then plug them in the original holes on the stock.
3. To grind the toe end of microCell pad, it is necessary to use a high speed machine. We recommend to employ a 400 grit sanding belt for finish. Best results can be achieved by the use of a new and lubricated belt.
4. Finally, during the grinding, the stock should be gently drawn close to the belt. This will avoid overheating and damaging the recoil pad.
